Installing The Lift - Zepro ZHZ 500-850 Installation Instruction

Installation
7.2

Installing the lift

1. Mount the lift to the chassibracket without tightening the screws. The number of screws and
theír placement depends on the type of bracket used, see Fig 32.
2. Use the adjusting screws for adjusting the armstop to make the height difference between
the center on the lift arms shaft hole and the wehicles body floor to approx. 1 inch, see Fig
32.
3. Then adjust the lift as close as possible to the backdoors, taking into account the platform.
NOTE!
Foldable platform requires more space.
4. Tighten the mounting screws using a torque wrench. Tightening torque 80 Nm.
Art. no.
72807TL
76013TL
73029TL
74914TL
75018TL
73169TL
73167TL
74451TL
74452TL
75236TL
50
Arm stop adjusting screw
Front hole pattern
Rear hole pattern
Hole pattern, front Hole pattern, rear
2 screws M12x35 mm 3 screws M12x35 mm
2 screws M12x35 mm 3 screws M12x35 mm
2 screws M12x35 mm 3 screws M12x35 mm
2 screws M12x35 mm 2 screws M12x35 mm
2 screws M12x35 mm 2 screws M12x35 mm
2 screws M12x35 mm 3 screws M12x35 mm
2 screws M12x35 mm 3 screws M12x35 mm
2 screws M12x35 mm 2 screws M12x35 mm
2 screws M12x35 mm 3 screws M12x35 mm
2 screws M12x35 mm 3 screws M12x35 mm
Fig 32. Mounting and adjustment of the lift
25 mm
www.zepro.com