Control Devices - Zepro ZHZ 500-850 Installation Instruction

Installation
7.6

Control devices

If the vehicle is equipped with two-handed grip this
means that the operator must use both hands to be
able to operate the loading platform, while this protects
the operator from pinch point .
1. Install the control devices in the required loca-
tions. However, they must be located so that the
operator is in the safest possible working position
and has a clear view of the load, the tail lift and its
working area
2. The distance between the vehicle's rear edge
and the centre of the controllers must be be-
tween 300-600 mm. The distance between the
controllers must be at least 260 mm.
NOTE.
All cable inlets must be directed downwards.
3. The control device's cable is connected to the con-
trol card,see "8.1 ZHZ-600-850 MAConnection to
circuit board" on page 64. When mounting more
control devices, the control devices shall be con-
nected to the circuit board, see "8.2 Connection to
circuit board 4 – button operation" on page 65.
m
WARNING!
A controller must always be fitted on the side that is facing away from traffic in motion. If there is a need for a controller on
the opposite side, a further controller must therefore be fitted. Fitting on the other side involves increased risk of injury.
54
Fig 42. When installing control devices for two-
handed grip, a distance of at least 260 mm
Fig 43. Installing control device
300 - 600 mm.
Min. 260 mm.
is required between the control devices
www.zepro.com