Adjustment Of Tilt Cylinder - Zepro ZHZ 500-850 Installation Instruction

Installation
7.14

Adjustment of tilt cylinder

m
WARNING!
Take great care during test operation
before adjusting the tilt cylinder to
ensure that the vehicle body is not
damaged.
Make sure that the tilt cylinder is ad-
justed in such a way that the platform
does not catch on the vehicle body
when the platform is tilted up fully.
1. Undo the locking nut.
2. Turn the piston rod clockwise to angle
down the platform or anti-clockwise
to angle up the platform. Lock the lug
in place using a suitable tool.
Adjust the tilt cylinder in horizontal
position.
NOTE.
The maximum permitted adjust-
ing distance is 30 mm.
3. After adjusting, tighten the locking
nut. Tightening torque 80 Nm
62
Fig 59. The tilt cylinder can be adjusted
so that the lift platform stops in the verti-
cal position behind the rear doors.
Fig 60. Undo the locking nut.
+
Fig 61. Turn the piston rod clockwise to
angle down the platform or anti-clock-
wise to angle up the platform.
30 mm
Fig 62. The maximum permitted ad-
justing distance is 30 mm
www.zepro.com