Temporary Operation Of Lift; Connection; Operation; Disconnection - Zepro ZHD 2500-130 Installation Instructions Manual

Temporary operation of lift

7 Temporary operation of lift
When the lift is installed, it is sometimes necessary to operate the lift functions in order to change the posi-
tion of the cylinders and the lift arms. To do this, the lift control card can be connected temporarily to run the
functions. To access the lift's control card, see section "8 Hydraulic unit and control card" on page 34.
NOTE.
The battery charger must not be connected when operating the lift. Risk of damage.
With this connection, closing against the vehicle body does not work.
7.1

Connection

1. Connect a suitable control device to the control card, see illustration below. The number of available func-
tions varies depending on the lift model.
2. Connect an earth connection (GND) and +12/24V to the lift. See also section "16.2 Maximum power
consumption -
Minimum recommended conductor cross sectional area" on page 64.
3. Insert a jumper between CSPWR and CS to simulate a cabin switch CS in the ON position, see Image 52.
7.2

Operation

Use the control device to run the lift functions.
m
WARNING!
Take great care when running the lift functions and make sure nothing is trapped. There is a risk of injury
and damage.
7.3

Disconnection

1. Remove the jumper between CSPWR and CS.
2. Disconnect +12-24 V from the platform.
3. Disconnect the earth connection from the platform.
4. Disconnect the control device from the control card.
www.zepro.com
Outputs
Control voltage
Up
B
Down
E
Ctrl 1
Tilt
C
2H
2H1
B
E
Ctrl 2
C
2H2
Ctrl 6
B
E
Ctrl 3
Radio
C
Lock
Ctrl 5
B
E
Ctrl 4
Spiral
C
Lock
Image 52. Temporary connection of lift control card
+
Sensor Power
IN OUT
PA-
PA+
CSPWR
Jumper
CS
Di 6
Di 5
Di 4
Di 3
Di 2
Di 1
Ai 1
Ai 2
ZHD 2500-130/150
33