Markings, Positioning Of Decals On Lift - Zepro Z 150-135 Installation Instruction

(see pictures on next page)
The loading diagram plates should be placed near
the control unit and in a clearly visible position on
the platform. The plate clearly indicates the nominal
loading and the diagram shows the
maximum permitted loading at different positions on
the platform.
The name plate is installed on the support frame of
the tail lift and contains the following information:
-Lift type
-Maximum permitted load in kg
-Serial number
-Year of manufacture
-Address and tel. no. of the manufacturer
-Country of manufacture
-EU type no. for bumper bar certificate
There is also a similar name plate in the form of a
decal which is to be affixed to the cabin's door frame
to ensure correct product identification.
The mark below represents the manufacturer's gua-
rantee that the tail lift is designed and was supplied
according to the requirements laid down in the Euro-
pean Machinery Directive. It is a customer's guaran-
tee of high quality and safety.
A "danger area" decal is also to be placed on the
platform warning drivers who are parking cars be-
hind the vehicle that 5 m are necessary to allow for
platform opening and sufficient manoeuvring space
for loading and unloading goods.
10. Markings, decals
An operating instructions decal should be placed
next to the main control unit.
A danger zone decal, warning of the danger area
between the platform and the vehicle bed is to be
affixed on the inside of the vehicle body near to the
spiral cable control, if installed.
We suggest that you stick the warning tape along
the side edge of the platform to make it more clearly
visible when in the horizontal position.
Install the warning flags, as close to the top and to
the side of the platform as possible, however, en-
sure that the flags will not detach when the platform
reaches the ground. Crimp the ends of the flag profi-
les so that the flags stay in position.
33