Installation; Installing The Lift - Zepro ZHZ 500 Installation Instruction

Installation

5 Installation
5.1

Installing the lift

1. Mount the lift to the chassibracket without tightening the screws. The number of screws and theír placement
depends on the type of bracket used, see installation instruction for the mounting kit in question.
2. Use the adjusting screws for adjusting the armstop to make the height difference between the center on
the lift arms shaft hole and the wehicles body floor to approx. 1 inch, see Fig 9.
3. Then adjust the lift as close as possible to the backdoors, taking into account the platform.
NOTE!
Foldable platform requires more space.
4. Tighten the mounting screws using a torque wrench. Tightening torque 80 Nm.
www.zepro.com
Arm stop adjusting screw
Rear hole pattern
Fig 9. Use the adjusting screws for adjusting the armstop
Art. no. Front hole pattern
72807TL 2 screws M12x35 mm
76013TL 2 screws M12x35 mm
73029TL 2 screws M12x35 mm
74914TL 2 screws M12x35 mm
75018TL 2 screws M12x35 mm
73169TL 2 screws M12x35 mm
73167TL 2 screws M12x35 mm
74451TL 2 screws M12x35 mm
74452TL 2 screws M12x35 mm
75236TL 2 screws M12x35 mm
Front hole pattern
25 mm
Rear hole pattern
3 screws M12x35 mm
3 screws M12x35 mm
3 screws M12x35 mm
2 screws M12x35 mm
2 screws M12x35 mm
3 screws M12x35 mm
3 screws M12x35 mm
2 screws M12x35 mm
3 screws M12x35 mm
3 screws M12x35 mm
ZHZ 500/600-850
13