Control Power Cable - Zepro ZHZ 500-850 Installation Instruction

Installation
7.8

Control power cable

NOTE.
See also the relevant vehicle manu-
facturer's electrical instructions.
1. If the control power cable is not pre-
routed, e.g. VDHH, route the control
power cable from the driver's cab to
the lift.
NOTE.
When passing through a mem-
ber or wall, the cable must be
protected by rubber grommets.
If there are any quick-release
connectors, make sure these
are effectively protected against
moisture and dirt.
2. Connect the control power cable to
the cab switch (CS) on the vehicle's
instrument panel. Connect to the ve-
hicle's electrical system via 10 A (24
V), 15 A (12 V) fuse according to the
customer's wishes.
56
Fig 45. Quick-release connectors must well protected
www.zepro.com