Zepro ZHZ 500-850 Installation Instruction page 29

Installation
7.1.6 VW Crafter, MB Sprinter 3665
(part no. 73167TL)
Models from 2006
NOTE.
It may be necessary to create a cut-
out in the bumper.
1 Dismantle the spare wheel and
associated mounts and ladder. Any
towing hook must also be removed.
2 Install outer and inner chassis
brackets in the vehicle chassis. Use
four M12x100 screws (out of a total
of nine). See Fig 24.
3 Install the spacer tubes. See Fig 25.
4 Drill a Ø12.5 hole in the frame from
the outside and inside, using the
outer and inner chassis brackets as
a template. See Fig 26.
5 Apply rustproofing agent in the
drilled hole.
6 Install the remaining 5 x M12x100
screws (out of a total of nine)
through the frame as well as M12
M6MF nyloc nuts. Tighten all 9
screws with the aid of a torque
wrench. See Fig 27. Tightening
torque 80 Nm
7 Install the lift, see "7.2 Installing the
lift" on page 50.
8 Install the platform, see "7.3 Install-
ing the Platform" on page 51.
www.zepro.com
Fig 24. Install outer and inner chassis brackets in
the vehicle chassis. Use four M12x100 screws.
Fig 25. Install the spacer tubes.
Drill Ø12.5 hole
Fig 26. Install outer and inner chassis brackets in
the vehicle chassis. Use four M12x100 screws.
Fig 27. Install a total of 9 x M12x100 screws through
the frame as well as M12 M6MF nyloc nuts. 80 Nm.
Screw M12x100
29