Table of Contents
Advertisement
Safety rules
3.5
Prepare the tail lift
1. Position the support frame under the vehicle's chassis.
2. Remove the protective cover mounted with a rubber strap; see Figure 18.
3. Fold out the control card / relay card (B) and loosen the cabling at the connector on the hydraulic unit; see
Figure 19 and Figure 20.
4. Release the hydraulic unit by unscrewing the wing nut and corresponding screw (C); see Figure 21 and
pull out the hydraulic unit until the tank cap is accessible; see Figure 23.
m
CAUTION!
Make sure no cables are pinched or in any other way damaged when the control card / relay card is folded out or removed.
Do not pull out the hydraulic unit more than necessary; make sure it is not pulled completely out of the frame, as this can
entail a risk of injury and damage to the equipment.
Figure 18. Remove the protective cap
Figure 20. Connection socket
www.zepro.com
Z 1500/2000-135/155/175
A
Figure 19. Release mechanism
C
Figure 21. Releasing the hydraulic unit
B
15
Advertisement
Table of Contents
