Installing The Angle Sensor - Zepro ZHZ 500-850 Installation Instruction

Installation
7.4

Installing the angle sensor

If the lift is equipped with radio control,
associated angle sensor must be
mounted on the platform, see Fig 38.
Use sensor bracket, art. no. 53937TL
(Ordered separately).
1. Mark the position of the bracket
holes on the platform and drill suit-
able holes.
2. Mount the bracket (Art. no.
53937TL) using the attached two
pop rivets, see Fig 38.
3. Mount the angle sensor with the
connection cable pointing upvards
and out on the bracket using the at-
tached screws, see Fig 39.
4. Mount the cable among existing
cables using cable ties and connect
to the 4 – button operation circuit
board. See section "8.2 Connection
to circuit board 4 – button operation"
on page 65.
NOTE.
The cable must be installed suf-
ficiently far from or be protected
against sharp edges, so that it
cannot chafe or otherwise sustain
damage that can lead to a short
circuit or cable fire.
In general, care must be taken
whenever routing cables, in
order to ensure a longer cable
service life and to reduce the
risk of unnecessary operational
stoppages.
52
Fig 38. Mounting of bracket and angle sensor
Fig 39. Attache the angle sensor
Fig 40. Mounted angle sensor
www.zepro.com