Table of Contents
Advertisement
Before installation
3.4
Rear beam cut outs
It is often necessary to create cut outs in the rear beam to provide space for the platform arms when the plat-
form is in the upper position. The size of the cut outs depends on the calculated installed dimension "A", see
illustration below.
1. Measure and mark the location and depth of the cut outs on the rear beam. The two cut outs must be
centred on the rear beam, i.e. both cut outs must be an equal distance from the mid-point of the beam.
2. Cut along the markings.
3. Grind away any burr or sharp edges.
3.5
Prepare the tail lift
1. Position the support frame under the vehicle chassis.
2. Remove the connection unit cover, secured with four screws, see Image 19.
Relay card/control
card
16
A max
245
Image 18. Rear beam cut outs
Image 19. Connection unit
ZAHD, ZAEHD 150/200-155/175
994
245
www.zepro.com
Advertisement
Table of Contents
