Table of Contents
Advertisement
Before installation
3.9
Prepare the tail lift
1. Position the support frame under the vehicle's chassis.
2. Remove the protective cover mounted using to quick release locks; see Image 18.
3. Fold out the control card / relay card (B) and loosen the cabling at the connector on the hydraulic unit; see
Image 19 and Image 20.
4. Release the hydraulic unit by unscrewing the wing nut and corresponding screw (C); see Image 21 and
pull out the hydraulic unit until the tank cap is accessible; see Image 22.
m
CAUTION!
Make sure no cables are pinched or in any other way damaged when the control card / relay card is folded out or removed.
Do not pull out the hydraulic unit more than necessary; make sure it is not pulled completely out of the frame, as this can
entail a risk of injury and damage to the equipment.
5. Check whether the hydraulic tank is fitted with a transport plug seal. If so, replace it with the regular tank
Image 18. Remove the protective cap
Image 20. Connection socket
www.zepro.com
A
Image 19. Release mechanism
C
Image 21. Releasing the hydraulic unit
ZN 2500-130/150
B
19
Advertisement
Table of Contents
