Table of Contents
Advertisement
Specifications
13.4
Maximum power consumption – Minimum recommended conductor
cross sectional area
Pump – Motor unit
Magnet (hydr. unit)
Magnet (electrical hose rupture valve)
Solenoid
Minimum recommended conductor cross sectional area
(copper cables, positive and negative cables)
Control cable
Supply line, L < 8 m
Supply line, L = 8-15m
Supply line, L > 15 m
Battery
Min. capacity, I
Min. voltage during operation, U
(when lifting)
13.5
Battery maintenance
When storing for longer than 1 week, you are recommended to disconnect the lift from the bat-
tery via the main switch or by releasing the lift's main fuse, in order to reduce the risk of the bat-
tery discharging. The length of time the vehicle can be stored without the battery's charge level
becoming too low depends on the condition of the battery, the charge level prior to storage and
how much power the vehicle's other components take from the battery. After a period of storage,
the battery must always be charged fully before operating the lift.
When installing the lift and when carrying out servicing and repair work, when the lift is operated
repeatedly without the vehicle being started and used, a battery charger must be used between
operations to maintain the battery's charge level.
NOTE.
The battery charger must not be connected when operating the lift. Risk of damage.
www.zepro.com
190 bar
min
min
I
min
-
+
L
I
min
-
+
Fig 74. Maximum power consumption – Minimum
recommended conductor cross sectional area
12 volt
24 volt
110 A
60 A
1.4 A
0.7 A
1.5 A
0.75 A
1.8 A
0.9 A
1.5 mm
1.5 mm
2
2
35 mm
35 mm
2
2
35 mm
35 mm
2
2
-
35 mm
2
140 Ah
110 Ah
9 volt
18 volt
U
min
L
NOTE.
Ensure that the lift has
access to the minimum
recommended power
capacity (I
)
Some
min
.
vehicle models have
restrictions regarding
the amount of power the
lift can access from the
existing battery.
U
min
79
Hide quick links:
Advertisement
Table of Contents
