Calculating The Installed Dimensions; C-Dimension; D-Dimension; H-Dimension - Zepro ZHZ 500-850 Installation Instruction

Calculating the installed dimensions

5 Calculating the installed dimensions
For easier installation, it is useful to calculate and specify the necessary dimensions in advance.
Determine the C-dimension first, then obtain the other dimensions from the relevant table. You
should try to position the lift as high as possible within the specified C-dimension in the table.
5.1

C-dimension

The C-dimension is the distance between the top the support frame and the vehicle floor level.
This dimension governs how far the lift needs to be installed under the vehicle body (D-dimension)
and the space between the lift arms in the upper position and the vehicle floor level (A-dimension).
5.2

D-dimension

The D-dimension is the space that the lift needs, measured from the rear edge of the body to the
front edge of the support frame (in the direction of the vehicle). Once the C-dimension has been
determined, the D-dimension can be obtained from the table.
5.3

H-dimension

The H-dimension is the height from ground (unloaded) to the vehicle floor level. The H-dimension
must not be greater than the lift's maximum lifting height. The lift's platform must always be able
to reach ground level.
12
C D
450 557
400 597
350 629
300 640
250 674
200 688
150 698
D
C
297
www.zepro.com