Shift The Image Roughly To Create Binding Space - Canon varioPrint 115 Operation Manual

Shift the Image Roughly to Create Binding Space

Shift the Image Roughly to Create Binding Space
Introduction
If you want to create space for staples or punch holes, for example, you can use the [Align]
function. The preview in the right-hand pane of the control panel displays the consequences of
your changes.
The [Align] function allows a rough image shift. You can select one of the following settings:
[Align] values
When you select:
[Top left]
[Top center]
[Top right]
[Center left]
[Center]
[Center right]
[Bottom left]
[Bottom center]
[Bottom right]
NOTE
You cannot change this setting for the active print job .
Procedure
1.
On the control panel, touch [Jobs] -> [Queues] -> [Scheduled jobs] or [Waiting jobs], or select a
DocBox.
2.
Touch the job you want to change.
3.
Touch [Properties], or double-tap the job to open the [Properties] window.
4.
Touch the [Align] button.
5. Make the required changes.
6. Press [OK].
174 Chapter 9 - Carry Out Print Jobs
Then the image is moved to:
The upper left corner of the sheet.
The upper center of the sheet.
The upper right corner of the sheet.
The left-hand side of the sheet, over the center line.
The middle of the sheet.
The right-hand side of the sheet, over the center line.
The lower left corner of the sheet.
The lower center of the sheet.
The lower right corner of the sheet.
Canon varioPRINT DP line