Power Buttons And Power Modes - Canon varioPrint 115 Operation Manual

Power Buttons and Power Modes

Power Buttons and Power Modes
The Power Buttons
The printer has the following switches and buttons to control the power supply.
Button
The Power Modes
You can find the energy saving settings in the Settings Editor under [Preferences] -> [System
settings] -> [Energy save modes].
The power modes
Power mode
Off
Ready
Low power mode Off
42 Chapter 4 - Start the print system
Name Description
On/Off button The On/Off button is located on top of the printer. Using
the On/Off button starts up or shuts down the whole sys-
tem, including the PRISMAsync controller.
Sleep button The Sleep button is located at the right-hand side of the
control panel. Using the Sleep button puts the printer in-
to sleep mode or wakes the printer up from the sleep
mode. When you press the Sleep button, the control
panel will be turned off too. The PRISMAsync controller
remains on.
The Sleep button allows you to switch between the
Ready mode and the Sleep mode. This is only possible
when the On/Off button is On and the start-up phase is
completed.
Control panel Description
Off The printer and the controller are completely off. There
is no power consumption. The printer cannot receive or
print any job.
On The printer is ready to print jobs.
The low power mode is an energy save mode.
To use the low power mode, the [Low power mode tim-
er enabled] setting in the Settings Editor must be set to
[Yes]. When this setting is disabled, the printer skips the
low power mode and goes into the sleep mode or deep
sleep mode after the time set for these modes.
When the printer has been idle for the time defined in
the [Low power mode timer] setting, the printer goes in-
to low power mode automatically.
Possible values: 5 - 30 minutes.
Factory default: 20 minutes.
The printer wakes up when a job arrives in the list of
[Scheduled jobs] or when you touch the control panel
(either the screen or any button).
4
Canon varioPRINT DP line