Canon varioPrint 115 Operation Manual page 336

Settings back side
[Z offset ({0})]
Ranges
Setting
[X offset ({0})]
[Z offset ({0})]
NOTE
If the shift is too much, the image be printed over the edges of the sheet.
• Risk of reprinting.
• Risk of system pollution.
Trapezoid Shape Image
When to do
The trapezoid shape is perpendicular to the feed direction.
Canon varioPRINT DP line
What to enter
The image is shifted in Z direction (perpendic-
ular on the feed direction) in mm (inches).
A shift > 0 moves the image to the top of the
sheet:
• The distance between the top of the sheet
and the image on the sheet decreases.
• The dots on the verification chart move to
the top of the sheet.
A shift < 0 moves the image to the bottom of
the sheet:
• The distance between the top of the sheet
and the image on the sheet increases.
• The dots on the verification chart move to
the bottom of the sheet.
Range (mm)
-5.0 to +5.0
-2.5 to +2.5
Chapter 13 - Media Handling
Trapezoid Shape Image
Range (inches)
-0.197 to +0.197
-0.098 to +0.098
335