Canon varioPrint 115 Operation Manual page 358

Group of settings
[Remote connection]
(optional)
[System settings]
Group of settings
[System settings]
Procedure
NOTE
The key operator PIN or the system administrator password is required to make changes in
this section.
1. Touch [System] -> [Setup] -> [System configuration] (under [Advanced]).
Canon varioPRINT DP line
Change a number of settings in the Settings Editor via the control panel
Available settings
• [Remote connection
status] (read-only)
• [eRDS connection]
(read-only)
• [Remote connection
enabled]
• [Remote Service
country code]
• [Remote Service
custom country
code]
• [Service organiza-
tion ID]
• [Test Remote con-
nection]
• [Date and time]
• [System of meas-
urement]
• [Media weight]
• [Time zone]
• [Show install wiz-
ard after next start-
up]
Available settings
• [Update finisher
configuration]
• [Bulk tray 1 media
size]
• [Bulk tray 2 media
size]
Short description
The [Remote connection] section (optional)
contains the settings to enable the remote con-
nection and to configure the Remote Service.
NOTE
Only Service can adapt the remote
connection settings. After Service
adapts the remote connection set-
tings, you can test the remote con-
nection with this setting.
The [System settings] section contains a/o set-
tings to change the date and time of the sys-
tem, or the system of measurement used.
When you change the system of measure-
ment, all corresponding values on the system
will be changed. For example, when you
change [Metric] into [Imperial], all length val-
ues will be displayed in inches. You can also
indicate how the media weight is displayed.
Short description
Furthermore, when a new finisher was added
to your configuration, you can use the [Update
finisher configuration] function to tell the sys-
tem that your configuration was updated. Then
the finisher will be added to the output loca-
tions in the job parameters section, for exam-
ple.
From the [System settings] you can also indi-
cate the media in the bulk trays one and two.
NOTE
A5 and Statement are only valid if
the bulk tray for small format is in-
stalled and configured by the service
technician. If you select A5 or State-
ment and the bulk tray for small for-
mat is not installed, you are not able
to assign media to the bulk tray.
Chapter 14 - Maintain the print system 357