Canon varioPrint 115 Operation Manual page 44

Power mode
Sleep mode
Deep sleep mode Off
Canon varioPRINT DP line
Control panel Description
Off Once the printer has been idle for the time defined in the
[Sleep mode timer] setting in the Settings Editor, the
printer goes into sleep mode automatically. Compared
to the low power mode, the printer uses less energy.
Possible values: 31 - 240 minutes.
Factory default: 40 minutes.
The printer wakes up when:
• You press the Sleep button
• A wake-up timer expires, or
• A job arrives in the list of [Scheduled jobs], provided
Press the Sleep button
control panel to put the printer into the sleep mode man-
ually. The printer goes into the sleep mode after all jobs
are finished.
When the [Deep sleep mode enabled] setting is set to
[Yes], the printer goes into the deep sleep mode.
The deep sleep mode is an alternative to the sleep mode
described above. To use the deep sleep mode, the [Deep
sleep mode enabled] setting in the Settings Editor must
be set to [Yes]. Also sleep mode must be enabled.
In the deep sleep mode:
• The printer uses less energy than in sleep mode.
• The printer needs more time to wake up than in sleep
that the [Automatic wake-up enabled] setting in the
Settings Editor is set to [Yes].
mode.
NOTE
An application in your workflow may require
the printer to wake up more quickly. If the
printer does not wake up quick enough, the
application may give an error. In that case it is
advised to disable the deep sleep mode. Then
the printer will use the sleep mode instead.
Chapter 4 - Start the print system
Power Buttons and Power Modes
on the control panel, or
on the right-hand side of the
43