Canon varioPrint 115 Operation Manual page 373

Perform a Paper Path Registration
NOTE
Make sure that the registration sheets are placed correctly in the left-hand upper corner
of the glass plate. Make sure that the registration sheet on the glass plate is not curled
or has dog ears. You can use a stack of paper to reduce the curl.
You must close the ADF / cover for each scan.
The instructions for the paper path registration are the same as the instructions for the automatic
media specific registration.
4.
Repeat step 1, 2 and 3 for A3/Ledger.
The tray for the A3/Ledger bulk media is tray 3.
After you finish
If the front-to-back side registration is not satisfactory after you performed the paper path
registration, you must check the actual sheet length in the feed direction. The paper path
registration assumes nominal sheet length. If the actual sheet length differs from the nominal
sheet length, you must enter the actual sheet size (see
media registration is not correct you must perform the manual media registration for this media
Option 2 - Manual Media Registration Adjustment (Only Needed in Incidental Cases) on
(see
page 325).
NOTE
Previously performed media specific registration can influence the media registration for bulk
media. To verify the paper path registration, we therefore recommend to set all media specific
registration settings to 0.
372 Chapter 14 - Maintain the print system
Registration Values on page
328). If the
Canon varioPRINT DP line