Canon varioPrint 115 Operation Manual page 361

Introduction to the [Setup] Section
Num‐ Item
ber
6 [Control panel settings]
7 [Shut down system]
8 [Advanced media settings]
9 [Intermediate check print]
10 [Accounting]
11 [System configuration]
360 Chapter 14 - Maintain the print system
Description
Adjust the brightness and contrast of the screen of the
control panel.
Shut down the printer and the controller in a controlled
way.
• Enable or disable the [Pre-printed mode].
• Enable or disable the [Wax mode].
• Set the paper quality factor to [Normal], [Low] or
[Lower].
Print a test sheet of a running job to check the quality.
Define the [Accounting mode] and the [Account ID]. The
[Accounting mode] is only available when the [Identifica-
tion enabled] setting in the Settings Editor on the PRIS-
MAsync controller is set to [Yes].
Get direct access to a number of important key operator
settings in the Settings Editor on the PRISMAsync con-
troller.
Canon varioPRINT DP line