Canon varioPrint 115 Operation Manual page 60

Attribute
[Sort]
[Media]
[Fit to media]
[Print sides]
[Orientation]
[Rotate 180 degrees]
[Tumble]
[Impositioning]
[Impositioning size]
[Front or booklet cover]
[Front cover print on]
[Back cover]
[Back cover print on]
[Perfect binding]
[Offset stacking]
[Staples]
[Output location]
[Sheet order]
[Feed edge]
Canon varioPRINT DP line
Description
You can indicate whether the jobs must be sorted [By Set] or [By
Page].
You can enter the media that must be used.
You can indicate whether every page must be scaled to the media
size.
You can indicate whether the jobs must be printed one-sided or
two-sided.
You can indicate whether the prints must be [Portrait] or [Land-
scape].
You can indicate that the prints must be rotated 180 degrees.
You can indicate the orientation of page images on opposite sides
of a sheet.
When [Tumble] is set to [Yes], the two pages are oriented in such
a way that the binding is at the top or bottom. The image is rota-
ted 180 degrees on alternate pages. Both sides of the page are
printed. However, the position of the image is reversed (from top
to bottom) on every other page.
When [Tumble] is set to [No], the binding is at the left or right. The
images are not rotated on alternate pages.
NOTE
[Tumble] is only possible when the setting [Print sides]
is set to [2-sided].
You can indicate how the prints must look, for example [2-up] or
[Same 2-up].
You can indicate the size of booklet jobs.
You can indicate which media must be used for the front covers or
booklet covers.
You can indicate which sides of the front cover must be printed.
You can indicate which media must be used for the back covers.
You can indicate which sides of the back cover must be printed.
You can indicate where the binding must be done, for example
[Left binding] or [Right binding]
You can indicate whether each next job or set must be stacked
with an offset compared to the previous job or set.
You can indicate where the prints must be stapled, for example
[Top left] or [Top right].
You can indicate where the jobs are sent, for example to the stack-
er.
You can indicate the order in which the sheets will be delivered,
for example [Face down - Normal order].
You can indicate whether the sheets will be fed [Long edge] or
[Short edge].
Introduction to Automated Workflows
Chapter 5 - Prepare the print system
4
59