Canon varioPrint 115 Operation Manual page 198

The Items of the [Transaction] Section
Description of the [Transaction] section
Num‐ Item
ber
1 Dashboard
2 [Connection]
3 [Print protocol]
4 [Image shift]
Sequence of Steps to Print Transaction Jobs
The following table describes the sequence of steps for transaction printing. Make sure that the
list of [Scheduled jobs] is empty before you begin.
Step Actions on the print‐
er
1 Switch the printer in-
to the transaction
printing mode.
2 Select the active set-
up that you need.
Canon varioPRINT DP line
Function
The dashboard displays the following information for
transaction printing.
• The connection status
• The IP address of the host that sends the jobs
• The name of the active transaction job
• The progress of the active transaction job
The [Connection] section gives access to the following
functions.
• Turn the transaction printing mode on or off
• Select the setup for the transaction jobs
You can define setups in the Settings Editor ([Transac-
tion printing] -> [Setups]).
• Put the printer online or offline. The printer must be
online for the host to be able to connect to the printer.
Display the active printer description language (read-on-
ly).
You can change the active PDL in the Settings Editor
([Transaction printing] -> [Settings] -> [Requested active
PDL]).
When the requested active PDL is changed, the new PDL
becomes effective when you put the printer online.
Display and change the active image shift settings, for
example when the images on the front and back of a
sheet are not aligned correctly.
Actions on the host
Introduction to the [Transaction] Section
Remarks
Via the control panel: [System] ->
[Transaction] -> [Transaction print-
ing mode] -> [On].
• Via the control panel: [System] -
> [Transaction] -> [Active trans-
action setup], or
• Via the Settings Editor: [Trans-
action printing] -> [Setups], or
• By the host via the data stream
(when the printer is online and
connected).
Chapter 9 - Carry Out Print Jobs
4
197