Change The Stacking Method Per Job - Canon varioPrint 115 Operation Manual

Change the Stacking Method per Job

Introduction
The [Offset stacking] function creates a visible distinction between sets or jobs in an output
location. The active workflow profile or the active automated workflow determines the default
type of offset stacking.
You can only change the type of [Offset stacking] per job when the [Offset stacking] setting of the
active [Workflow profile] is set to [Sets (as in job)].
NOTE
You cannot change this setting for the active print job .
Procedure
NOTE
Remember that you can only change the stacking method per job when the active
[Workflow profile] is set to [Sets (as in job)].
1.
On the control panel, touch [Jobs] -> [Queues] -> [Scheduled jobs] or [Waiting jobs], or select a
DocBox.
2.
Touch the job you want to change.
3.
Touch [Properties], or double-tap the job to open the [Properties] window.
4.
Touch the [Print delivery] button.
5. Touch the [Offset stacking] button to toggle between [On] and [Off].
6. Press [OK].
Canon varioPRINT DP line
Change the Stacking Method per Job
Chapter 9 - Carry Out Print Jobs 177