Optimize The Scan Quality - Canon varioPrint 115 Operation Manual

Optimize the Scan Quality

Introduction
The printer can detect photos, rasters and fine lines on the original. This information is processed
in such a way that the digital result has a high scan quality. This means that in most cases you do
not need to adjust quality settings to get the best result.
Problems and Solutions
Overview of possible scan problems and solutions
Description of the problem
All the pages are upside
down
Every second page is up-
side down
All the pages are posi-
tioned sideways
The information on the
page is too large or too
small
The information on the
page is too light or too
dark
Procedure
1.
Place the originals face up into the ADF, or place one original face down on the glass plate.
2.
On the control panel, touch [Jobs] -> [Copy/Scan].
3.
Select a scan profile.
4.
Define the settings for the [Original]
5.
From the [Image type] setting, select the correct type of original ([Photo], [Text] or [Mixed])
6. Define the settings for the [File].
7. Select [Exposure].
Canon varioPRINT DP line
Solution
You placed the originals in the wrong direction into the automatic
document feeder (ADF) or on the glass plate.
Make sure the originals are placed correctly and scan the originals
again.
The [Original type] and [Size] settings that you selected do not
correspond with the orientation of the information on the origi-
nals.
Select the correct [Original type] and [Size] settings and scan the
originals again.
There is more than one explanation for this problem.
• Wrong orientation selected.
• Original feed direction confused with the orientation of the in-
formation on the original.
• The application you use does not process the TIFF/PDF file in
the right way.
Select the correct [Original type] and [Size] settings and scan the
originals again. If the problem remains, the application you use
can be the cause of the problem. Check the results in another ap-
plication.
This problem can occur when the size of the original and the se-
lected size of the target scan are not the same. The problem can
also be caused by a (manual) change in the zoom factor.
Check the size of the [Original] and the [File] on the operator panel
and scan the originals again.
You can change the [Exposure] settings to influence the result.
Optimize the Scan Quality
Chapter 11 - Carry Out Scan Jobs 267