Toro Multi Pro 5800-G Operator's Manual page 86

A. Clean the agitation valve and the 3
section valves; refer to
Agitation and Section Valves (page
B. Check the brakes; refer to
Brakes (page 68).
C. Service the air cleaner; refer to
the Air Cleaner (page
D. Grease the sprayer; refer to
the Spray Pump (page
E. Change the engine-oil filter and oil; refer
to Changing the Engine Oil Filter (page
57) and Changing the Engine Oil (page
58).
F. Check the air pressure in the tires; refer
to Checking the Tire Air Pressure (page
25).
G. Prepare the fuel system as follows:
i. Start the engine and run it at
idle speed for approximately 2
minutes.
ii. Shut off the engine.
iii. Flush the fuel tank with fresh,
clean fuel.
iv. Secure all the fuel-system fittings.
H. Use the starter to crank the engine and
distribute the oil inside the cylinder.
I. Check and tighten all bolts, nuts, and
screws.
Note:
Repair or replace any parts that
are worn or damaged.
J. Check the condition of all spray hoses.
Note:
Replace any hoses that are worn
or damaged.
K. Tighten all hose fittings.
L. Paint all scratched or bare metal
surfaces (paint is available from your
Authorized Service Dealer).
M. Store the machine in a clean, dry
storage area.
N. Remove the battery from the chassis,
check the electrolyte level, and charge
the battery fully; refer to
Battery (page 63).
Important:
The battery must be fully
charged to prevent it from freezing
and being damaged at temperatures
below 32°F (0°C). A fully charged
battery maintains its charge for about
50 days at temperatures lower than
4°C (40°F). If the temperatures will
Cleaning the
77).
Adjusting the
Checking
55).
Greasing
52).
Charging the
86
be above 4°C (40°F), check the water
level in the battery and charge it
every 30 days.
Note:
Do not connect the battery cables
to the battery posts during storage.
O. Remove the key from the starter switch
and put the key in a safe place out of the
reach of children.
P. Cover the machine to protect it and keep
it clean.