Toro Multi Pro 5800-G Operator's Manual page 60

5. Rotate the nut for the fuel pump/sending unit
counterclockwise and remove the nut and seal
(Figure 78)
6. Carefully lift and rotate the fuel pump/sending
unit out of the neck of the fuel tank
Important:
Use caution when handling the
fuel pump/sending unit to avoid damaging
the arm for the float of the sending unit.
Figure 79
1. Fuel-tank neck
2. Arm (sending-unit float)
3. Pickup tube (fuel filter)
(Figure 79).
g032543
4. Fuel pump/sending unit
5. Filter
6. Float
Replacing the Fuel Filter
1. Remove the pickup tube of the fuel filter from
the fitting of the fuel pump
Note:
Discard the fuel filter.
1. Fitting (fuel pump)
2. Float arm (full position)
3. Pickup tube
2. Align the pickup tube of the new fuel filter with
the fitting of the fuel pump
3. Align the long leg of the fuel filter with float when
the float arm is in the empty position
4. Insert the fuel-pump fitting into the pickup tube
until the fitting is fully seated
60
(Figure 80).
Figure 80
4. Float arm (empty position)
5. Fuel filter (short leg)
6. Fuel filter (long leg)
(Figure 80).
(Figure
(Figure 80).
g028351
80).