Toro Multi Pro 5800-G Operator's Manual page 51

Figure 63
1. Flange-head bolts (5/16 x
7/8 inch)
2. Undercarriage shroud
2. Remove the 4 flange locknuts (5/16 inch) from
the bolts and carriage bolt that secure the
mounting tabs of the undercarriage shroud
to the engine-mount brackets of the machine
(Figure 64).
Note:
Do not remove the bolts from
the machine. Retain the flange locknuts
for installation in step
Undercarriage Shroud (page
g189584
g189585
3. Washers (5/16 inch)
4. Front of the machine
3 of Installing the
51).
1. Engine mount
2. Bolt—shown for clarity; do
not remove
3. Mounting tabs
(undercarriage shroud)
3. Move the mounting tabs off of the bolts
that secure the undercarriage shroud to the
engine-mount brackets.
4. Remove the undercarriage shroud from the
machine (Figure 63
Installing the Undercarriage
Shroud
1. Align the undercarriage shroud to the bottom
chassis of the machine; refer to
Removing the Undercarriage Shroud (page
2. Move the mounting tabs of the undercarriage
shroud over the bolts and carriage bolt at the
engine-mount brackets of the machine; refer
to Figure 64 in
Shroud (page
3. Assemble the undercarriage shroud to the
engine-mount brackets and bolts
64) with the 4 flange locknuts (5/16 inch)
that you removed in step
Undercarriage Shroud (page
4. Align the holes in the rear part of the
undercarriage shroud with the holes in the
chassis; refer to
Undercarriage Shroud (page
5. Assemble the rear part of the undercarriage
shroud to the chassis
5 flange-head bolts (5/16 x 7/8 inch) and 5
washers (5/16 inch) that you removed in step
of Removing the Undercarriage Shroud (page
50).
6. Torque the nuts and bolts to 1129 to 1582 N∙cm
(100 to 140 in-lb).
51
Figure 64
4. Flange locknuts (5/16
inch)
5. Front of the machine
and Figure 64).
Figure 64
Removing the Undercarriage
50).
(Figure
2 of Removing the
50).
Figure 63 in Removing the
50).
(Figure 63) with the
g189583
in
50).
1