Setting The Section-Bypass Valves - Toro Multi Pro 5800-G Operator's Manual

Turf sprayer with excelarate spray system
Hide thumbs Also See for Multi Pro 5800-G:
Table of Contents

Advertisement

Setting the Section-Bypass
Valves
Manual Mode Only
Important:
When operating in application rate
mode, you must set the section-bypass valves to
the closed position.
Before using the sprayer for the first time, if you
change the nozzles, or as needed, calibrate the
sprayer flow, speed, and set the section bypass; refer
to
Setting the Section-Bypass Valves (page
Note:
Calibrate the section valves whenever you
change the nozzles.
Select an open flat area to perform this procedure.
1.
Fill the spray tank halfway with clean water.
2.
Lower the spray sections.
3.
Engage the parking brake.
4.
Set the spray control switch to manual.
5.
Set the 3 section switches to the O
but leave the master section switch in the O
position.
6.
Set the spray-pump switch to the O
and turn on the agitation.
7.
On the InfoCenter, navigate to the Calibration
screen and select Test Speed; refer to
Simulating a Test Speed in the Software Guide
for the Multi Pro 5800-D and 5800-G turf sprayer
with ExcelaRate spray system.
A.
Press buttons 3 or 4 to raise or lower the
simulated speed to 5.6 km/h (3.5 mph).
B.
Press button 4 to toggle O
simulation.
C.
Press button 5 to save and exit the
screen.
SPEED
8.
Using the application-rate switch, adjust the
application rate according to the table that
follows.
Nozzle Application Rate Table
Nozzle Color
Yellow
Red
Brown
Gray
White
Blue
Green
38).
9.
position,
N
FF
position,
N
1. Section-bypass
test speed
N
10.
TEST
11.
12.
13.
14.
15.
38
SI (Metric)
159 L/ha
319 L/ha
394 L/ha
478 L/ha
637 L/ha
796 L/ha
1,190 L/ha
Turn off the left-section switch and adjust the
section-bypass knob
(Figure
displayed is at the previous level according to
the table.
Note:
The numbered indicators on the bypass
knob and needle are for reference only.
Figure 38
adjustment knobs
Turn on the left-section switch and turn off the
right-section switch.
Adjust the right section-bypass knob
until the rate displayed is at the previous level
according to the table.
Turn on the right-section switch and turn off the
center-section switch.
Adjust the center section-bypass knob
38) until the rate displayed is at the previous
level according to the table.
Turn off the master section switch.
Turn off the spray pump.
English
Turf
17 gpa
0.39 gpk
34 gpa
0.78 gpk
42 gpa
0.96 gpk
51 gpa
1.17 gpk
68 gpa
1.56 gpk
85 gpa
1.95 gpk
127 gpa
2.91 gpk
38) until the rate
g191413
2. Sections-bypass shutoff
valve
(Figure
38)
(Figure

Advertisement

Table of Contents
loading

This manual is also suitable for:

41394

Table of Contents