Servicing The Hydraulic Fluid - Toro Multi Pro 5800-G Operator's Manual

US gallons) pails or 208 L (55 US gallons) from
your Mobil Distributor.
1. Position the sprayer on a level surface, engage
the parking brake, shut off the spray pump, shut
off the engine, and remove the key.
2. Clean the area around the hydraulic-fluid-tank
dipstick cap and remove it
Figure 92
1. Hydraulic-fluid tank
2. Vent
Important:
Be very careful not to get dirt or
other contaminants into the opening when
checking the fluid.
3. Wipe the dipstick clean with a cloth and replace
it completely in the tank.
4. Remove the dipstick from the filler neck and
check the fluid level
Note:
The fluid level should be within the
safe-operating range on the dipstick.
Figure 93
1. Dipstick
5. If the fluid is low, fill the tank with the specified
hydraulic fluid or equivalent to raise the level to
the upper mark.
6. Install the dipstick cap into the tank and secure.
(Figure 92).
3. Dipstick cap
(Figure 93).
2. Safe-operating range
Servicing the Hydraulic
Fluid
If the fluid becomes contaminated, contact an
Authorized Toro Distributor to have the system
flushed.
Note:
Contaminated fluid looks milky or black when
compared to clean fluid.
Replacing the Hydraulic-Fluid
Filters
Service Interval: After the first 5 hours
Every 400 hours/Yearly (whichever comes first)
Use the Toro replacement filter (See your Parts
Manual for the correct part number.)
g014217
Important:
Use of any other filter may void the
warranty on some components.
WARNING
Hot hydraulic fluid can cause severe burns.
Allow the hydraulic fluid to cool before
performing any maintenance to the hydraulic
system.
1. Position the sprayer on a level surface, engage
the parking brake, shut off the spray pump, shut
off the engine, and remove the key.
2. Locate the 2 hydraulic filters on the machine
(Figure 94
Note:
1 filter is below the hydraulic-fluid tank
and the other filter is located at the rear of the
machine on the frame.
•
Forward filter—below the hydraulic tank.
g014218
70
and Figure 95).