Toro Multi Pro 5800-G Operator's Manual page 37

Figure 37
1. Drain-valve bracket
2. Mount studs (drain valve)
4. Align the end of the valve with the drain
container and rotate valve handle to the open
position (Figure 37).
5. When the tank has drained completely, rotate
the drain-valve handle to the closed position and
assemble the valve onto the drain-valve bracket
(Figure 37).
Important:
Dispose of the sprayer tank
chemicals according to local codes and the
material manufacturer's instructions.
Cleaning the Sprayer
Important:
You must always empty and clean
the sprayer and any installed spray accessories
immediately after each use. Failure to do so may
cause the chemicals to dry or thicken in the lines,
clogging the pump and other components.
Toro recommends using the approved Clean Rinse Kit
for this machine. Contact your Authorized Toro Dealer
for more information.
Clean the spray system and any installed spray
accessories after each spraying session. To properly
clean the spray system:
•
Use 3 separate rinses.
g191083
3. Drain valve handle (open
position)
•
Use the cleaners and neutralizers as
recommended by the chemical manufacturers.
•
Use pure, clean water (no cleaners or neutralizers)
for the last rinse.
1. Fill the tank with at least 190 L (50 US gallons)
of clean, fresh water and close the cover.
Note:
You can use a cleaning/neutralizing
agent in the water as needed. On the final rinse,
use only clean, clear water.
2. Lower the outer spray sections into the spray
position.
3. Start the engine and move the throttle lever to a
higher engine speed.
4. Ensure that the agitation switch is in the O
position.
5. Set the spray-pump switch to the O
and use the application-rate switch to increase
the pressure to a high setting.
6. Set the individual section switches and master
section switch to the O
spraying.
7. Allow all of the water in the tank to spray out
through the nozzles.
8. Check the nozzles to ensure that they are all
spraying correctly.
9. Set the master section switch to the O
position, set the spray-pump switch to the O
position, and shut off the engine.
10. Repeat steps
to ensure that the spray system is fully cleaned.
Important:
You must always complete this
procedure at least 3 times to ensure that the
spray system and spray accessories are fully
clean, preventing damage to the system.
11. Clean the strainer; refer to
Filter (page 26).
Important:
If you used wettable powder
chemicals, clean the strainer after each tank.
12. Using a garden hose, rinse off the outside of the
sprayer with clean water.
13. Remove the nozzles and clean them by hand.
Note:
Replace damaged or worn nozzles.
37
N
positions to begin
N
1 through 9 at least 2 more times
Cleaning the Suction
N
position
FF
FF