Checking The Pcv Valve - Toro Multi Pro 5800-G Operator's Manual

Changing the Engine Oil
1. Align a drain pan under the drain plug
75).
2. Remove the drain plug
oil to drain completely.
Note:
Check the drain plug seal for wear
and damage; replace the seal if it is worn or
damaged.
Note:
Dispose of the used oil at a certified
recycling center.
3. Install the drain plug into the drain port of the
engine oil pan and tighten the plug to 33 to 37
N∙m (24 to 27 ft-lb).
4. Tilt the passenger seat forward and align the
prop rod into the detent in the prop-rod-guide
slot.
5. Remove the oil-filler cap from the filler neck of
the valve cover of the engine
slowly pour approximately 80% of the specified
amount of oil into the filler neck.
Figure 76
1. Low
2. Full
3. High
6. Remove the dipstick and check the oil level in
the engine (Figure
7. Slowly add additional specified oil to bring the oil
level to the full mark on the dipstick
Important:
Overfilling the engine with oil
may cause damage to the engine.
8. Install the oil-filler cap into the filler neck and the
dipstick into the dipstick tube
9. Start the engine and check for oil leaks.
10. Shut off the engine, wait 2 to 3 minutes, remove
the dipstick, and check the oil level in the engine.
(Figure
(Figure 75) and allow the
(Figure 76) and
4. Oil-filler cap
5. Dipstick
76).
(Figure
(Figure 76).
Note:
If needed, remove the oil-filler cap, add
the specified oil to bring the oil level to the full
mark on the dipstick, and install the oil-filler cap.
11. Install the dipstick, engine heat shield, and tilt
the seats down.

Checking the PCV Valve

Service Interval: Every 1,000 hours
1. Tilt the driver's seat forward and align the prop
rod into the detent in the prop-rod-guide slot.
2. Remove the PCV valve from the fitting of the
valve cover
Note:
Do not separate the hose from the PCV
valve.
1. Front of the machine
2. Hose (crankcase
ventilation)
g195189
3. Shake the PCV valve.
Note:
If the internal restrictor of the valve
rattles, the PCV valve is serviceable; if the
internal restrictor is not free to rattle when
shaken, replace the PCV valve
4. Insert the PCV valve until it is fully seated in the
seal for the valve-cover fitting
5. Lower the operator's seat.
76).
58
(Figure 77).
Figure 77
3. PCV valve
4. Valve-cover fitting
(Figure
(Figure
g028345
77).
77).