Toro Multi Pro 5800-G Operator's Manual page 45

Selecting a Pressure Filter
Available screen sizes include:
Standard Equipment: 50 mesh suction filter (blue)
Use the pressure filter table to identify the screen
mesh for the spray nozzles you are using based
on chemicals products or solutions with a viscosity
equivalent to water.
Pressure Filter Table
Spray Nozzle Screen Mesh
Color Code (flow Size*
rate)
As required for low 100
viscosity chemicals
or solutions or low
application rates
Yellow (0.2 gpm) 80
Red (0.4 gpm) 50
Brown (0.5 gpm) 50
50
Gray (0.6 gpm)
White (0.8 gpm) 50
Blue (1.0 gpm) 50
Green (1.5 gpm) 50
As required for high 30
viscosity chemicals
or solutions or high
application rates
As required for high 16
viscosity chemicals
or solutions or high
application rates
*The mesh size of the pressure filters in this table
are based on spray chemicals or solutions with the
viscosity equivalent to water.
Important:
When you spray with higher viscosity
(thicker) chemical products or solutions with
wettable powders, you may need to use a coarser
screen mesh for the optional pressure-filter; refer
to Figure 55.
Filter Color Code
Green
1. Higher-viscosity chemicals
Yellow
2. Lower-viscosity chemicals
Blue
Blue
Blue
When you spray at a higher application rate, consider
Blue
using an courser optional pressure-filter mesh; refer
to
Blue
Blue
Red
Brown
1. Higher application rate
2. Lower application rate
45
Figure 55
Mesh size—chemical or solution viscosity
or solutions
or solutions
Figure 56.
Figure 56
Mesh size—application rate
g214211
3. Screen mesh size
g214240
3. Screen mesh size