Toro Multi Pro 5800-G Operator's Manual page 57

day. If the engine was operated, allow the oil to drain
back down to the sump for at least 10 minutes before
checking.
The engine is shipped with oil in the crankcase;
however, the level of oil must be checked before you
first start the engine and after you have run it.
1. Position the machine on a level surface.
2. Remove the dipstick, located under the
passenger seat, and wipe it with a clean rag
(Figure 74).
Note:
Insert the dipstick into the tube and make
sure it is seated fully. Remove the dipstick and
check the oil level.
Figure 74
1. Low
2. Full
3. High
3. If the oil level is low, remove the filler cap from
the valve cover (Figure
filler neck until the oil level is up to the Full mark
on the dipstick.
Note:
Add the oil slowly and check the level
often during this process. Do not overfill.
4. Install the oil-filler cap
5. Install the dipstick firmly in place
g195363
g195189
4. Oil-filler cap
5. Dip stick
74) and pour oil into the
(Figure 74).
(Figure 74).
Changing the Engine Oil Filter
1. Remove the forward heat shield; refer to
Removing the Forward Heat Shield (page
2. Raise the seats.
CAUTION
Components under the seat will be hot
if the sprayer has been running. If you
touch hot components, you may be
burned.
Allow the sprayer to cool before
performing maintenance or touching
components under the hood.
3. Align a drain pan under the engine oil filter
(Figure 75).
1. Drain plug
4. Remove the old oil filter
Note:
Dispose of the used oil filter at a certified
recycling center.
5. Wipe clean the surface of the oil filter adapter of
the engine with a rag.
6. Fill the oil filter with the specified oil.
Note:
Allow the filter element to saturate with
oil.
7. Apply a thin coat of the specified oil to the rubber
gasket on the replacement oil filter.
8. Install the oil filter to the filter adapter and turn
the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter
an additional 1/2 turn
Note:
Do not overtighten the oil filter.
9. Wipe clean any residual oil.
57
Figure 75
2. Engine oil filter
(Figure 75).
(Figure 75).
50).
g028169