Toro Multi Pro 5800-G Operator's Manual page 71

Turf sprayer with excelarate spray system
Hide thumbs Also See for Multi Pro 5800-G:
Table of Contents

Advertisement

Figure 94
1. Hydraulic tank
Rear filter—located on the machine frame.
Figure 95
1. Rear filter
3.
Clean the area around the filter-mounting area.
4.
Place a drain pan under the filter.
5.
Remove the filter.
6.
Lubricate the new filter gasket with clean
hydraulic fluid.
7.
Wipe clean the filter-mounting area with a rag.
8.
Thread the filter on until the gasket contacts
the mounting plate, then tighten the filter an
additional 1/2 turn.
9.
Start the engine, set the throttle at fast idle, and
let the engine run 3 to 5 minutes at to purge air
from the hydraulic system.
10.
Shut off the engine and check the hydraulic-fluid
level and for leaks.
11.
Dispose of the used filter at a certified recycling
center.
g013791
2. Forward filter
g013790
2. Rear wheels
Changing the Hydraulic Fluid
Service Interval: Every 400 hours/Yearly (whichever
comes first)
Hydraulic-fluid capacity: 56 L (15 US gallons) of
the specified hydraulic fluid or equivalent; refer to
Checking the Hydraulic Fluid (page
Important:
Using any other fluid may void the
warranty on some components.
WARNING
Hot hydraulic fluid can cause severe burns.
Allow the hydraulic fluid to cool before
performing any maintenance to the hydraulic
system.
1.
Replace the hydraulic-fluid filters; refer to
Replacing the Hydraulic-Fluid Filters (page
2.
Clean the area around a hydraulic-hose fitting on
the bottom of the hydraulic-fluid tank
1. Hydraulic tank
3.
Place a large drain pan under the hydraulic tank
fittings.
4.
Remove the hose fitting from the tank, allowing
the fluid to drain into the pan
5.
Install the hose and fitting to the tank and tighten
it securely.
6.
Fill the hydraulic reservoir with approximately 53
L (14 US gallons) of specified hydraulic fluid or
equivalent; refer to
(page
69).
7.
Start the engine, set the throttle at fast idle, and
let the engine run 3 to 5 minutes at to purge air
from the hydraulic system.
71
69).
(Figure
Figure 96
2. Hydraulic hose and fitting
(Figure
96).
Checking the Hydraulic Fluid
70).
96).
g014219

Advertisement

Table of Contents
loading

This manual is also suitable for:

41394

Table of Contents