Toro Multi Pro 5800-G Operator's Manual page 33

to the Software Guide for the Multi Pro 5800-D
and 5800-G turf sprayers with ExcelaRate spray
system.
7. Set the spray section switch(es) to the O
position (Figure
1. Left spray-section switch
2. Center spray-section
switch
8. Set the agitation switch and the spray-pump
switch to the O
N
1. Sprayer-pump switch
2. Agitation switch
9. Set the throttle to the F
10. Drive at the desired speed and then set the
master section switch to the O
spraying (Figure
29).
Figure 29
3. Right spray-section switch
4. Master section switch
position (Figure 30).
Figure 30
3. Throttle
position (Figure
AST
position to begin
N
29).
Note:
and stop the flow of chemicals to the selected
spray sections.
11. When finished spraying, set the master section
N
switch to the O
sections, then set the spray-pump switch to the
O position.
FF
Note:
transport position and drive the sprayer to the
cleaning area.
Important:
until they have moved completely into
section-transport cradle forming the "X"
transport position and the lift cylinders
are fully retracted whenever you move the
sprayer from 1 spraying area to another, or
move to a storage or cleaning area.
Spraying in the Manual Mode
Note:
This procedure assumes that the spray pump
is on; refer to
g192944
Rate Mode (page
1. Ensure that the sprayer system is adjusted for
the active spray nozzles that you have selected;
refer to
38).
2. Set the sprayer mode button to the Manual
Mode
1. Manual mode position
g192636
3. Set the master section switch to the O
position; refer to
Application Rate Mode (page
4. Adjust the throttle to the desired engine speed
to spray; refer to
30).
Application Rate Mode (page
5. Drive to the spraying location.
6. Lower the sections into position.
33
Use the master section switch to start
position to turn off all spray
FF
Raise the outer spray sections to the
Always raise the spray sections
Figure 30 in Spraying in the Application
32).
Setting the Section-Bypass Valves (page
(Figure 31).
Figure 31
2. Sprayer-mode switch
Figure 29 in
Figure 30 in
g195516
FF
Spraying in the
32).
Spraying in the
32).