Accessing The Engine - Toro Multi Pro 5800-G Operator's Manual

Figure 60
1. Rear jacking points

Accessing the Engine

Removing the Forward Heat Shield
1. Engage the parking brake, shut off the spray
pump, shut off the engine, and remove the key.
2. Raise the front and back of the machine and
support it with jack stands; refer to
Sprayer (page 49).
3. Remove the 6 hex-head bolts and 6 washers
that secure the front, forward heat shield to the
chassis and remove the shield
Note:
Retain the bolts, washers, and heat shield
for installation in
Shield (page 50).
Figure 61
1. Forward heat shield
Raising the
(Figure 61).
Installing the Forward-Heat
2. Hex-head bolts and
washers
Installing the Forward-Heat Shield
1. Align the rear flange of the forward heat shield
over the forward flange of the rear heat shield
(Figure 62).
g203111
1. Front of the machine
2. Hex-head bolts and
washers
2. Align the holes in the forward heat shield with
the threaded holes in the chassis
3. Assemble the forward heat shield to the machine
with the 6 hex-head bolts and 6 washers
62) that you removed in step
Forward Heat Shield (page
4. Torque the bolts to 1978 to 2542 N∙cm (175 to
115 in-lb).
5. Remove the jack stands and lower the machine.
Removing the Undercarriage
Shroud
1. Remove the 5 flange-head bolts (5/16 x 7/8
inch) and 5 washers (5/16 inch) that secure the
rear of the undercarriage shroud to the chassis
of the machine
Note:
Retain the flange-head bolts and
washers for installation in step
g028168
Undercarriage Shroud (page
50
Figure 62
3. Rear flange (forward heat
shield)
4. Forward flange (rear heat
shield)
(Figure
3 of Removing the
50).
(Figure 63).
5 of Installing the
51).
g028177
62).
(Figure