Operating The Spray Sections - Toro Multi Pro 5800-G Operator's Manual

Important:
Prior to introducing wettable
powders into any Toro Spray System mix
the powders in a suitable container with
sufficient fresh water to create a free flowing
slurry. Failure to do so may result in
chemical deposits on the bottom of the tank,
degraded agitation, clogging of filters, and
improper application rates.
Toro recommends using the approved
Eductor Kit for this machine. Contact your
Authorized Toro Dealer for more information.
8. Add the proper amount of chemical concentrate
to the tank, as directed by the chemical
manufacturer.
9. Add the remaining water to the tank, remove the
fill hose, and close the tank cover.
Note:
To seal the tank, close the cover and
rotate the front half clockwise.
Operating the Spray
Sections
The boom-section lift switches on the sprayer control
panel allows you to move the outer spray sections
between transport position and spray position without
leaving the operator's seat. Whenever possible, stop
the machine before changing spray section positions.
1. Stop the sprayer on level ground.
2. Use the boom-section lift switches to lower the
outer spray sections.
Note:
Wait until the sections reach the
fully-extended spray position.
3. When you need to raise the spray sections, stop
the sprayer on level ground.
4. Use the boom-section lift switches to raise the
outer spray sections.
Note:
Raise the sections until they have moved
completely into section transport cradle, forming
the "X" transport position and the section
cylinders are fully retracted.
Important:
To prevent damage to the
section-actuator cylinder, ensure that the
actuators are fully retracted before transport.
Important:
Release the actuator switch once
the sections have reached the desired position.
Running the actuators against the mechanical
stops may damage the lift cylinders and/or other
hydraulic components.
Operating the Boom-Transport
Cradle
The sprayer is equipped with a boom-transport cradle
that has a unique safety feature. In the event of
accidental boom contact with a low overhead object
while in the transport position, the boom section(s)
can be pushed out of the transport cradles. If this
occurs, the boom sections will come to rest in a
near-horizontal position to the rear of the vehicle.
While this movement will not damage the outer boom
sections, they should be immediately put back into
the transport cradle.
Important:
The outer spray sections can be
damaged by transporting them in any position
other than the "X" transport position using the
boom transport cradle.
To put the boom sections back into the transport
cradle, lower the boom section(s) to the spray
position, and then raise the boom section(s) back into
the transport position. Ensure that the lift cylinders
are fully retracted to prevent actuator rod damage
during storage.
31