Table of Contents
Advertisement
5.19 ID Settings
Clear
Clear the spectrum acquired hitherto and restart data collection.
Default
Reset the gain to the factory default. The spectrum will be cleared and the instrument
will start recalibration from the beginning.
Calibrate
Save the fine gain value determined by the calibration procedure and have it used for
future measurements. (Only available after enough data for a calibration have been
collected, see Fig. 74, p. 77).
Exit
Return to the superior screen.
5.19 ID Settings
You can access the identification settings of the radEAGLET-R via this menu (Fig. 75, p. 78).
Settings and Commands
Exit
Return to the superior screen.
Down
Highlight the next item. Cycles to the top item after you reached the last item.
Select
Select the highlighted item.
5.20 Easy ID Settings
This screen (Fig. 76, p. 79) groups the settings for the Easy ID mode.
Settings and Commands
Preset Time
Specify the measurement duration in seconds for the easy ID mode (see 3.2, p. 37).
78/163
Easy ID Settings . . . . . . . . . . . . . . . . . . see 5.20, p.
Nuclide Library . . . . . . . . . . . . . . . . . . . see 5.21, p.
Figure 75:
The ID settings menu
Software 3.2.12r • Document 3.3.3b4o
radEAGLET-R User Manual
78
79
© innoRIID GmbH • 2020-11-18
Advertisement
Table of Contents
