Powercell In Compartment With Cover Removed - Ametek Ortec radEAGLET-R Series User Manual

radEAGLET-R User Manual
To remove the powerCELL...
1. Unscrew both locks of the cover by turning them counter-clockwise. You can use the
attached bracket or, for example, a coin.
You don't need to remove the screws completely, just turn them until the cover
loosens.
2. Remove the cover (Fig. 130, p. 123).
Figure 130:
3. Grab the flap and pull the powerCELL out of the instrument.
To install a powerCELL...
1. Slide the powerCELL into the compartment, contact side ahead.
The case of the powerCELL is asymmetric. It fits into the compartment in the
correct orientation only.
2. Put the cover on the compartment.
3. Lock the cover by turning both locking screws clockwise.
8.3 External Power Sources
You can connect the radEAGLET-R to external power sources via the connector on the rear
side of the instrument Fig. 4, p. 20.
Included with the radEAGLET-R are:
• Wall power supply (8.3.1, p. 124)
• Car adaptor
© innoRIID GmbH • 2020-11-18

powerCELL in compartment with cover removed

Software 3.2.12r • Document 3.3.3b4o
Powering the radEAGLET-R
powerCELL with Flap
Locking Screws
123/163