Calibration - Ametek Ortec radEAGLET-R Series User Manual

5.18 Calibration

radiation dose. If you set the alarm levels or warning thresholds too high, this may
pose a serious health risk to you.
You can set the unit used for these thresholds under 5.4, p. 56.
Warning Threshold
The dose rate threshold for warnings. The value must be lower than that for alarms.
Alarm Threshold
The dose rate threshold for alarms. The value must be higher than that for warnings.
Neutron Sensitivity
Set sensitivity for neutron alarms in several steps.
This item is available for radEAGLET-R models with a neutron detector (see E.1,
p. 153).
Exit
Return to the superior screen.
Down
Highlight the next item. Cycles to the top item after you reached the last item.
Change
Edit the highlighted setting.
5.18 Calibration
This screen (Fig. 73, p. 77) shows a partial spectrum and some additional information you
can use to inspect and trigger the calibration of your radEAGLET-R.
For additional information refer to appendix C.2, p. 148.
A simpler version of calibration is available too, see 5.14, p. 71.
76/163
Setting Neutrons
-5
-4
-3
-2
-1
Default ±0
+1
+2
+3
+4
+5
Software 3.2.12r • Document 3.3.3b4o
Integration Duration
4
4 10 sec
4 15 sec
4 20 sec
4 30 sec
4 40 sec
4 80 sec
4 100 sec
4 140 sec
4 180 sec
4 220 sec
radEAGLET-R User Manual
4 sec
© innoRIID GmbH • 2020-11-18