9.5 Transfer Results
5. If the spectrum is insufficient for the identification of nuclides, a corresponding mes-
sage is displayed. This could, for example, happen with a weak source or a too short
acquisition duration. Press
additional data for the spectrum. You can press
6. If you are not satisfied with the confidence of the result, you can try to enhance it with
Continue
9.5 Transfer Results
You can access measurement results and settings of your radEAGLET-R with other devices
such as computers or mobile phones. In this guide, we connect the radEAGLET-R to a com-
puter via cable. Various other methods are supported for the physical connection between
the devices, see chapter 6.2, p.
To connect the radEAGLET-R to a computer...
1. Start up the radEAGLET-R and the computer.
2. Connect the USB connector of the radEAGLET-R to a USB host connector of the
computer with the included cable.
3. You can verify the connection on your computer, see 6.2, p.
Usually you don't need to install additional software on your computer. If in doubt,
refer to section 6.2, p. 95.
138/163
Figure 149:
Continue
as described in the previous step.
95
for details.
Software 3.2.12r • Document 3.3.3b4o
The Easy ID results
to add the preset duration again and collect
Continue
radEAGLET-R User Manual
as often as needed.
95
for details.
© innoRIID GmbH • 2020-11-18