Cleaning Instructions; Daily Cleaning Instructions; Weekly Cleaning Instructions - Insinger CX20 Series Technical Manual

CLEANING INSTRUCTIONS

DAILY CLEANING
The following cleaning procedures should be done daily, at
the end of the shift:
1. Remove all internal removable parts including spray
manifolds, scrap screens, drain overflow tubes and
suction strainers.
2. Remove the end caps from the spray arms and clean
with the brush provided. Flush the arms.
3.
Flush scrap screens of matter. Inspect drain overflow
and clean as necessary.
CAUTION:
V-cup seal on the drain stopper may become gummed
which will not allow the stopper to seat properly. This
will cause the drain to leak water. Remove any build-up
on the V-cup seal. When the seal becomes worn,
replace.
5. Remove all internal removable parts including spray
arms, scrap screens, drain stopper and
suction strainers.
CAUTION:
Improper cleaning of suction strainers will cause
the pumps to cavitate. This will cause poor
washing results.
Clean tank level airtrap (1 per tank) with a
6.
sponge. DO NOT use steel wool.
CAUTION:
Air trap must be cleaned daily. Build-up of
grease and scum will cause faulty operation of
tank fill and heating system.
7. Final rinse nozzles must be cleaned of matter.
8. Doors must be left open to allow drying of interior
surfaces.
CX20 SERIES
PART 4 CLEANING INSTRUCTIONS
WEEKLY CLEANING
1. The entire machine should be wiped down using an
industrial grade stainless steel cleaner.
2. Under the supervision of your detergent supplier the
machine interior must be properly de-limed.
NOTE :
The water quality in some areas requires
de-liming to be done more frequently.
Contact your detergent supplier for
recommended de-liming frequency.
DELIME CYCLE
The length of the Delime cycle can be set in the Settings menu.
You can set the length to be anywhere from 5 to 15 minutes.
1. Hold the Cycle button for 2 seconds to activate Delime
Mode. The indicator LEDs will flash magenta to show that
you are in Delime Mode. The display will give you
instrcutions on how to proceed.
2. Open the drain lever and allow the machine to drain. The
indicator LEDS will turn off from top to bottom to show the
progress.
3. When the LEDs flash magenta, close the drain and make
sure the door is also closed. The machine will fill.
4. Once the machine is filled and up to temperature, open the
door and put the delime chemical into the tank.
5. Close the door and the machine will run the delime wash
cycle.
6. When the cycle is complete, the indicator LEDs will flash
magenta. Open the drain lever to drain the machine.
7. The LEDs will flash magenta once the machine is drained.
Close the drain lever and allow the machine to fill.
8. Once the machine is filled, the machine will start to run for
the flush cycle.
9. At the end of the flush cycle, the indicator LEDs will flash
and the display will tell you to drain the machine.
10. After the machine is fully drained, close the drain and allow i
to fill and reach temperature.
11. The machine is now ready to wash ware.
11 www.insingermachine.com 800-344-4802