Operation Instructions - Insinger CX20 Series Technical Manual

OPERATION INSTRUCTIONS

These instructions are intended for the daily users of this
machine:
PREPARING MACHINE
1. Close the drain lever.
2. Check for proper installation and cleanliness of all
internal, removable components such as scrap
screens and spray manifolds.
3. Ensure all water and steam lines are open.
4. Ensure electrical circuits are on.
5. Close machine door.
STARTING MACHINE
1. Press the power button to turn the machine on. The
display will turn on and the machine will start to fill. If
the indicator lights flash red the door or drain is open,
check the display for instructions.
2. The indicator lights will illuminate blue from bottom to
top to show the progress of the filling process. The
display will show the fill pressure. The heaters will
come on once the tank is approximately 20% full.
3. When the tank is full the heaters will stay on until the
wash tank temperature is met. The indicator lights will
illuminate orange from botom to top to show the
progress of the heating process. The display will show
the wash tank temperature.
4. Once the machine is ready, the indicator lights will
turn green.
CAUTION:
Proper wash tank temperature is 160 F minimum.
Proper final rinse temperature is 180 F minimum
at 20 5 PSI, while in the final rinse cycle.
WASHING A RACK
1. Open the door.
2. Insert a rack of soiled dishware in machine and
lower doors. The machine is equipped with
RackAware and will start the wash and rinse
automatically. The machine will not run if there
isn't a rack present.
CAUTION:
Overloading racks will minimize the proper
cleaning of ware.
CX20 SERIES
PART 3 OPERATION INSTRUCTIONS
WARNING:
Do not open the doors during the cycle as
hot water is being sprayed. An interlock is
provided to stop the wash/rinse cycle if the
doors are opened but hot water may spray
out if doors are opened too quickly.
3. The indicator lights will illuminate blue from
bottom to top to show the cycle progress.
When the machine cycle is completed the
indicator lights will flash green.
4. Open the door and remove rack of clean ware.
5. For continuous operation, repeat steps 2 - 4.
EXTENDED CYCLES
The CX20 has three cycles. The cycle lengths can
be set by following the instructions in Section TK.
The machine will default to Cycle 1 so to run Cycle
2 or 3 do the following:
1. With the door open, press the cycle button to
choose your cycle, it is below the power
button. Press the button twice to select Cycle
2 and three times to select Cycle 3.
2. Once you have selected your cycle close the
door to start the wash.
3. After the cycle, the machine will automatically
go back to Cycle 1.
SHUTDOWN
1. Upon completion of ware cleaning press the
power switch to turn the machine off.
2. The lights will flash red and the display will tell
you to Drain Machine. Open the drain.
3. The indicator lights will turn off from top to
bottom and then the machine will turn off.
4. Report any unusual occurrences to qualified
service personnel.
10 www.insingermachine.com 800-344-4802