Table of Contents
Advertisement
LT-40 LOW TEMPERATURE CHEMICAL
SANITIZING DOOR TYPE SERIES
CLEANING INSTRUCTIONS
DAILY CLEANING
1. Remove and clean drain stopper pipe.
2. Once the tank is drained, remove the sump and
drain strainers. Flush the strainers.
3. Remove the wash arms. Remove the endcaps and
flush the wash arms. Ensure all nozzles are clear
of matter.
4. Leave doors open to allow drying of interior
surfaces.
WEEKLY CLEANING
1. The entire machine should be wiped down using
a commercial foodservice stainless steel cleaner.
Do not use steel wool.
2. Under the supervision of your detergent supplier
the machine interior must be properly delimed.
Refer to the DELIME INSTRUCTIONS.
DELIME INSTRUCTIONS
1. Disconnect the chemical feeder pumps.
2. While the doors are closed turn MAIN POWER
switch to the ON position.
3. Press and hold the FILL button for approximately
10 seconds to fill the tank.
4. While the doors are closed turn MAIN POWER
switch to the OFF position.
5. Fill the dishmachine with the correct amount
of delime solution as recommended by the
manufacturer of the chemicals.
6. Close the doors. Turn the MAIN POWER switch to
the ON position.
7. Flip the DELIME switch to the DELIME position.
This will cause the machine to run continuously.
NOTE:
The DELIME switch is located on the
back of the control box.
LT-40 Series Technical Manual 2018
®
13
PART 4
CLEANING INSTRUCTIONS
7. Run the machine for the recommended length of
time.
8. Flip the DELIME switch to NORMAL.
9. Press and hold the DRAIN button to empty the
tank.
10. Turn the MAIN POWER switch to the OFF position.
11. Open the doors and step away for 5 minutes.
12. Inspect interior of the unit for lime deposit. If the
results do not meet expectations, repeat steps 2
to 11.
13. Close the doors and turn the MAIN POWER switch
to the ON position.
14. Refill the unit by holding the FILL button for
approximately 10 seconds.
15. Flip the DELIME switch to the DELIME position
and run the unit for 10 minutes.
16. Flip the DELIME switch to the NORMAL position.
17. Press and hold the DRAIN button to empty the
tank.
18. Turn the MAIN POWER switch to the OFF position.
19. Open the doors.
20. Reconnect the chemical feeder pumps.
21. The machine is ready to use.
▲
WARNING:
!
Use of deionized water or other
aggressive fluids will result in
corrosion and failure of materials and
components. Use of deionized water
or other aggressive fluids will void the
manufacturer's warranty.
NOTE:
The water quality in some areas
requires deliming to be done more
frequently. Contact your detergent
supplier for recommended de-liming
frequency.
www.insingermachine.com
800-344-4802
Advertisement
Table of Contents
