Installation Instructions - Insinger Commander 18-6 Technical Manual
High temperature door type dishmachine
Hide thumbs
Also See for Commander 18-6:
Advertisement
COMMANDER 18-6 DOOR TYPE SERIES
INSTALLATION INSTRUCTIONS
These installation instructions are intended for qualified
equipment installers:
PLACEMENT
Carefully uncrate machine. Take caution not to damage
components which may be mounted on the top or
sides of the machine. Set unit in place and adjust the
feet to level the machine.
TABLING
Load and unload tables should be pitched towards the
machine to return excess water into the machine.
Fasten the tables to the load and unload side of the
machine. Most installations require fastening the turn-
down lip of the dish tables to the side of the machine
with flathead countersunk screws.
The table design should provide horizontal clearance
of 30" for servicing.
ELECTRICAL CONNECTIONS
Connect electrical lines sized for the correct voltage,
current and phase of the machine. These should
agree with the machine requirements indicated on the
nameplate and labels on the control panel.
Model
208VAC/3PH
18-6/18-6C
Steam heat
18-6/18-6C
Electric heat
18-6/18-6C
Electric heat
Insinger SCB
18-6H/18-6HC
Steam heat
18-6H/18-6HC
Electric heat
18-6H/18-6HC
Electric heat
Insinger SCB
Commander 18-6 Technical Manual 2018
®
FUSE SIZING CHART
240VAC/3PH
10A
10A
20A
20A
60A
50A
10A
10A
25A
25A
60A
60A
PART 2 INSTALLATION INSTRUCTIONS
A single-point electrical connection is provided for the
pumps, control circuit, and wash tank heater.
If an electric booster is provided, connect power
directly to the booster.
If the Insinger Self-Contained booster is provided
the machine comes standard with a Single-Point
Connection (to include the booster).
Connections must be made to a circuit breaker or
fused disconnect as provided by the end-user and
required by local codes. A laminated wiring diagram
is inside the control panel.
As with any 3 phase system, an electrician must
check all motors for proper phasing, i.e., Pump
motors must be running in direction indicated by
arrow on housing.
380VAC/3PH
480VAC/3PH
6A
10A
30A
10A
15A
35A
www.insingermachine.com
8
CAUTION:
CAUTION:
220VAC/1PH
6A
10A
25A
6A
15A
30A
100A
800-344-4802
15A
35A
90A
20A
40A
Advertisement
