Maintenance Requirements; Maintenance Procedures; Changing Settings - Insinger CX20 Series Technical Manual

MAINTENANCE REQUIREMENTS

This section is intended for qualified service and/or
maintenance technicians.
The following maintenance should be conducted quarterly:
1. Remove and clean the strainer screens on water
and steam lines. If the screens cannot be cleaned,
replace.
2. Inspect the condition of the fill solenoid valve seats
and diaphragms. Replace as necessary.
3. Inspect drain o-rings for leakage. Replace where
necessary.
4. Check wash and rinse hub bushing/bearing and
replace where necessary.

MAINTENANCE PROCEDURES

Solenoid Valve Disassembly (SK-5825)
1. Disconnect the power supply to the machine.
2. Turn off the water supply.
3. Remove cap on top of the coil. Remove the coil.
4. Remove the 4 hex bolts and lift bonnet from valve
body. Note positioning of spring and plunger.
5. Remove main piston.
6. Inspect for dirt, wear or lime build-up. Clean or
replace as required.
7. Reassemble in reverse of disassembly.
CX20 SERIES

CHANGING SETTINGS

This section is intended for qualified service and/or
maintenance technicians.
To access the settinngs menu you must open the control
box. Unscrew the screws that hold the control box cover in
place, there is one on the front and one on the side. You
will now be able to access the 4-button switch on the right
side of the control box.
1. To open the settings menu, press and hold button
#4 for 2 seconds. The display will now show the
programmable options.
2. Scroll through the options using buttons #1 and #2.
3. When you have found the setting you wish the
change, press button #3.
4. You will now be able to adjust the value up by using
button #3 and down using button #4.
5. When you have set the value, press button #2 to
accept.
6. To exit the menu press button #4.
12
PART 5 MAINTENANCE
www.insingermachine.com 800-344-4802