User Code - Troxler Enhanced RoadReader Plus 3451 Manual Of Operation And Instruction

USER CODE

The User Code function enables the operator to change the code
used to access certain gauge functions. The code can be any numeric
value from 1 to 9999. When shipped, the access (user) code is set to
the value shown on page xv.
To change the code, press the 〈User Code〉 button on the Gauge
Setup menu. The PDA requests the current user code, as shown in
Figure 5–7 on page 5–8. Enter the access code using the PDA's
Block Recognizer, Keyboard, Letter Recognizer, or Transcriber
functions, and press the 〈Done〉 button. (For more information on
these functions, refer to the documentation provided with the PDA.)
The PDA displays the Change User Code Menu shown in
Figure 5–8. Enter the new code and press the 〈Done〉 button. The
PDA displays a confirmation message showing the entered code and
the question Is this correct? Press the 〈OK〉 button to accept the
new code and return to the Gauge Setup menu, or the 〈Cancel〉
button to return to the Change User Code Menu.
Figure 5–9. Change User Code Menu
Model 3451 5–9