Size F 200 V
Connection of a regenerative resistor
Short bar
Size
(accessory)
F
Installed
* The circuit connected to terminal X1 – X7 are secondary circuits. (See [ 5. Appearance and name of each part ])
Insulation is needed against the primary side power supply (power supply of the motor brake).
Please do not connect them with the same power supply.
* The standard of the ability of the built-in dynamic brake resistor is up
to continuousness three times in the stop from the allowance and maximum inertia and the rated speed.
Resistor is damaged and the dynamic brake might not work when using it under more critical operating condition.
* For details, refer to 7-1 Power connector XA, XB, XC, XD, and terminal block.
R2.0
Internal
regenerative
In case of using the external
resistor
regenerative resistor
Between RB and B:
Disconnect the short bar
Installed
Between P and B:
Connect the external
regenerative resistor
Connection of the Terminal
In case of not using the external
Between RB and B:
Connect the short bar
Industrial Device Solution Business Unit, Panasonic Corporation
No. SX-DSV03335 - 54-
regenerative resistor