Size C, D 100 V / 200 V
Connection of a regenerative resistor
Short wire
Size
(accessory)
C
Installed
D
* The circuit connected to terminal X1 – X7 are secondary circuits. (See [ 5. Appearance and name of each part ])
Insulation is needed against the primary side power supply (power supply of the motor brake).
Please do not connect them with the same power supply.
* For details, refer to 7-1 Power connector XA, XB, XC, XD, and terminal block.
R2.0
Internal
regenerative
In case of using the external
resistor
regenerative resistor
Between RB and B:
Disconnect the short cable
Installed
Between P and B:
Connect the external
regenerative resistor
Connection of connector XB
In case of not using the external
Between RB and B:
Connect the shorting cable
Industrial Device Solution Business Unit, Panasonic Corporation
No. SX-DSV03335 - 52-
regenerative resistor